| CAMPERS | ||
|---|---|---|
| Are all all interior and exterior fabric panels clipped in? | ||
|
Are all the panels at the same height and the gaps between panels are even? |
||
| Are there any fiberglass strands are exposed along edge of interior panels? | ||
| Are all interior trim pieces are snapped in place with no large gaps? | ||
| Does the door operate smoothly with no uneven gaps when closed, and the brush strip on the bottom just touches the threshold? | pg. 41-42 | |
| Does the magnetic seal close even and tight? Look for light gaps between the metal strip on the door and the magnet. | see article for adjustment | |
| Are the bolts on the door top track snug? (black bolts) These prevent movement of the rail. | pg.55-56 | |
| Do the Bluetooth controls buttons work properly? Do the network IDs match on all three hoops? | ||
| Are the light blockers installed between the roof panels? | pg.46 | |
| Are there any factory labels visible on any "A" surfaces? | ||
|
Are all HPL panels at the same height and have even gaps between panels? HPL panels can be rotated 180 degrees to correct uneven panels across the top. |
||
| Are all the plastic trim pieces on top of corners and hoops installed. | ||
| Does the fascia line up properly? The front and rear upper horizontal beam may need adjusting where it bolts to the corner casting to correct fascia not positioned flush. | ||
| Is the power cord too long? Can it be secured inside the outer hoop cover? | ||
|
Is the door handle hardware torqued to 2nm? Is the door roller hardware torqued to 14nm? |
pg.37 | |
| Are the louvers fully closing to the center? | pg.47 | |
| ACCESSORIES-KINK/CABIN | ||
| For the cabin, are the fascia trim gaps even on both ends? | ||
| Are the exterior panels fully snapped in and lined up with the exterior panels on the camper? | ||
| ACCESSORIES-AWNING | ||
| Corded | ||
| Is the awning centered on the camper? | ||
| Are all the cord clips in place? | ||
| Are all the cord ends secured neatly in the cord clamp clip? Is the frayed cord exposed? Is the cord free from defects? | ||
| Is the cord installed with even tension with no sagging areas? | ||
| Are the cross braces leveled and lined up with the cording? | ||
| Wood and PET slats | ||
| Are all the wood slats secured with screws? Are any warped? | ||
| Are all the PET slats installed with braces? Are the PET slats straight and even? | ||
| Fabric | ||
| Is the fabric stretched evenly, without wrinkles or puckers | ||
| Are all cut fabric edges are tucked into the rubber channels. Are all extra fabric fibers trimmed? | ||
| Are all the fabric corner clips installed, holding the fabric tight? | ||
| ACCESSORIES-TABLES & MONITOR BRACKETS | ||
| Is the table level in both directions? | ||
| Is the monitor bracket level and at the desired height? | ||
| ACCESSORIES-HACK | ||
| Is the hack centered on the camper? | ||
| Are all the slats seated in the clamps at the same height? Are any wood slats warps? | ||
| If the wavy slats are ordered, are they in the correct numerical order? | ||
| Are the adjustable feet set correctly to support the hack? |
Comments
0 comments
Please sign in to leave a comment.