Downloadable version availible at the bottom of the page.

⚠️ IMPORTANT INFORMATION

This article provides instructions for connecting service hoops together on Air27 and Air29 pods so that lighting and fan functions operate simultaneously from a single user control panel.

Purpose of Hoop‑to‑Hoop Connection

Interconnecting service hoops allows:

• Lights to operate together across connected hoops
• Fans to operate at the same time
• A single user panel to control multiple service hoops

Required Components

• RJ45 communications cable – 3.5 m

A standard 3.5 m RJ45 comms cable is used to link the service hoops.

Hoop‑to‑Hoop Connection Instructions

Step 1 – Interconnect Service Hoops

• Locate the data ports inside each service hoop
• Connect the hoops together using a 3.5 m RJ45 cable

Once connected, all lights and fans will operate together from one user panel.

Step 2 – Connect Service Hoop to Building Data

• Plug data cables into the building supply (floor or wall connection)
• Feed data cables through the hoop grommet
• Connect cables to the sockets located inside the service hoop cover

Ensure all cables are fully seated and routed cleanly through grommets to avoid pinching or damage.

Critical Notes

• Use only approved RJ45 cables of appropriate length
• Confirm all connections before powering the system
• Ensure cables are routed through grommets to prevent damage
• Improper connections may result in lights or fans not operating correctly

Reference

Air27 / Air29 Hoop‑to‑Hoop Connection
Americas Technical Document – Section 8

This Zendesk article is intended as an installer‑facing reference and does not replace full electrical or installation documentation.